How can I ensure data accuracy and reliability?

Evaluate scan for (partial) Plates

An image of the scanned plate/block is shown on the computer. Make sure the red rectangular line is correctly showing the contour of the scanned plates (see image below). Click on individual samples to ensure that the red circle identifying each sample is well positioned in the center of the test well/cavity. When not well identified, reposition the plate, close the software and restart the reading session.

Note:  make sure no ‘overhanging’ flaps of adhesive foil’ is visual for the scanner as it will disturb the location of the plate/ plates/ blocks. This will result in the red line not following the full contour of the plate.

Note: after the scanning and calculation of the test results the multi plates will have a bottom view (and therefore mirror image) on the screen.

Press next to view the reading results. 

Evaluate the Scan for Ampoules

An image of the scan (ampoules) is shown on the computer. You can evaluate the test results by moving your cursor over the samples in the scan. 

Make sure the red line around the individual ampoules is correctly showing the contour of the scanned plates (see image below).  You may click on a ‘test ampoule’ to ensure location of all wells/cavities is correct. See the red line around the selected ampoules.

Press next to view the reading results. 

By double-clicking or by first selecting a sample and then pressing ‘Next’, this selection becomes active in the results list.